Ok, so I asked this question once but I am going to ask it again just differently. I have an 82 Honda cx500...The engine is seized and will not turn over. It has clean oil in it, and it has coolant (its water cooled). Its been sitting outside for two
On bikes the piston usually explans too much causing it to get stuck in cylinder. Now the ring is shot and if it did get unstuck the chance of it starting is very poor. Now if it did start then as soon as it gets hot the motor will seize again. I have
logsdodl | Mar 07, 2008
Honda CX engine CX650 starting.
Sick engine. Horrible noise..... ... CX 500 CX650 engine bag of spanners clutch ...
Honda CX500CB started after 11 years of being stood.
This is my 1981 Honda CX500 CB which had been stood for 11 years. Before starting it I had to free the clutch plates, change oil and oil filter ...
How to: Remove The Starter Clutch & Fly Wheel On A Briggs & Stratton
In the video i show you how to remove a Starter Clutch & Fly Wheel On A Briggs & Stratton. What is a "starter clutch"? The start ...
GY6 Installation Oil Pump & Starter Clutch
In this video, I show you how to remove and install an oil pump and starter clutch in a GY6 engine. All kinds of performance parts and stock OEM ...
